The PIVOT Power Rack is the perfect add-on for anyone looking to perform any of the myriad of strength-based exercises made possible by a rack. Now you don't have to dedicate a whole room to be a gym, you can have your gym stored under your bed.
Engineered from 3mm, high quality steel, the 75x75mm uprights bring the strength of a commercial power rack to your bedroom. The rack comes with adjustable, telescopic feet to enable it to pivot under the bed when not in use and then be driven into the floor securely using a strong lever on the back of each upright. This ensures that the rack always has a firm contact with the floor and takes the weight from the rest of the bed.
At the upper end of each upright is a further telescopic steel tube which allows the pull-up bar to reach a maximum height of 2.5 metres, or all the way down to below knee level (for non pull-up exercises...)
The uprights feature westside hole spacing in the lower area to give you finer control over barbell positioning (every 25mm), with the remainder having holes every 50mm.The included J-hooks are not your standard, cheap after-thoughts: we've designed them from one solid piece of 10mm steel, folded to perfection and with zero welds.
The 16mm diameter stainless steel pin is another premium feature not found on the cheap J-hooks normally included with racks. Not only do we use durable rubber to protect the J-hooks and your barbell, we also use rubber on all three sides of the clasp, ensuring the J-hooks don't damage your uprights. This is another common cost-cutting area – but not with PIVOT. The rack arms are held in place when folded-in using strong, adjustable webbing straps which hook into place and secure in seconds.
The rack can be extended and ready for exercise in seconds, and the same is true for stowing it again should you want to either return the bed to its sleeping position or merely perform different exercises using the entire available floor space.
The rack also comes with six beautiful, stainless steel magnetic locking pins. These help to ensure that, just like everything else with PVIOT Bed, there are no annoying rattles when in the sleeping position. These pins are used to secure the telescopic feet and the telescopic pull-up bar.
The mounting panels, which are part of the main PIVOT Bed product, have multiple holes allowing the rack to be mounted offset slightly to either side to help give you more room for your barbell, should your bed be close to a side wall.
The following article covers the best position for your PIVOT Bed.
The power rack add-on includes all the brackets and stainless steel nuts, bolts, washers and pins required to affix it to the PIVOT Bed, and this should take no longer than 30 minutes.
Estimated shipping date: August